Using Internal Oscillator

Just change this config option to select the Fast RC oscillator instead of PRIPLL. 


    #pragma config FNOSC = FRCPLL           // Oscillator Selection Bits (Fast RC Osc w/PLL)

The Fast RC oscillator is 8MHz so same other setup as using an 8MHz crystal, apart from the accuracy not being as good.

The POSCMOD setting is supposed to have no effect when FRC is selected – its value is don't care.  However we have found on some devices that if it is not set to off as below then the RA2 and RA3 pins often shared with the OSC1 and OSC2 pins won't work as IO:


	#pragma config POSCMOD = OFF

 

UK Electronic Designer
USEFUL?
We benefit hugely from resources on the web so we decided we should try and give back some of our knowledge and resources to the community by opening up many of our company’s internal notes and libraries through mini sites like this. We hope you find the site helpful.
Please feel free to comment if you can add help to this page or point out issues and solutions you have found, but please note that we do not provide support on this site. If you need help with a problem please use one of the many online forums.